Search results

No issues. In fact, I can hear a pin drop it is so quiet. I’m approaching 5k miles on my Taycan. Where in NJ are you? If you need help, we can try to coordinate a time to connect. Not an easy job, and we don’t want one repair to cause more problems. Private message me would be better than via...

Has anyone seen this ridge on another color? Perhaps it is on other colors, yet easier to spot on white?

Yes, I have similar on my Carrera White Taycan Turbo. The "ridge" on my Taycan is less pronounced, but textured like a brush stroke, which makes me believe it is a seam sealer that was painted white. My experience with seam sealer is - The more the better, as it most likely protects a pinch...

I'm sure the side marker will work without the spacer, but I believe it will work better with the spacer. There is a reason for it in the first place. From what I saw during my installation, the spacer contributed to a tighter fit, and I think that is necessary for long term durability. Just...

Thanks Felixtb. Unfortunately my NVH is occurring with lane keep assist off. I think LKA is a great tool, except here in New England where every road is lined in potholes. Sometimes I find the system pushing me back into a pot hole, which I would rather not hit, so I turn the system off and...

So I decided to forego the dealer and address the rattle myself. I have many reasons why I decided to take the risk, which I won't waste your time explaining, but in the end, I found a satisfactory result. Here's what I found. 1) B-pillar clip which appears to be anodized in green was...

Bill, love the multi-engine analogy as I'm a SEL Cirrus pilot myself! Thanks for the tip. I checked my TPMs and found the largest delta between all four tires to be 2 PSI. I reset all PSI to 38 (cold) per the manual for partial load and 21-inch all-season tires (I have the MissionE wheels)...

Hi All, I've read your comments above and I am curious if there was a design change. I am equally confused, but like you said, well worth the effort once you're done. -Nai

Peter! Thanks for the clue! I think I have the same problem: Definitely sounds like a clip that's loose. Thanks for chiming in.

Hi All, Under maintenance throttle at speeds between 60 MPH and 75 MPH, I'm stating to notice a resonating front axle noise. The noise follows a sin graph where it's frequency goes in and out at a constant rate, ascending and descending in vibration and noise level. It reminds me of a wheel...

I also have occasional rattles over rough roads from the passenger side doors / B or C Pillar. I peaked at the door trim and figured I wouldn't mess with it. I'm also going to have it looked at during my next service. Otherwise, as all have said, the Taycan is very tight. Took delivery of...

Nicely done!

My experience with optimal setting is that it charges to 100%, yet my goal is to charge only to 85% as it is my daily drive. For your car, does it charge to 85% on the optimal setting?

Good point! 00:00-00:01 not an option. But 00:00-00:05 is. I'll keep you posted!

I'm confused as well with maximizing 85% SOC in the profiles. Yet if I think like a programmer, I might set Min battery charge to "85%" & Preferred charge times "00:00 - 00:00." Wouldn't this mean, charge to 85% immediately and then no time allowed to charge past? Here's what I have for...

DIY: Replace Amber US DOT Side Marker with Clear LED Euro Side Marker. Required Parts: 1) OEM Porsche Part: 9J1-953-042-D 2) OEM Porsche Part: 9J1-953-041-D Required Tools: 1) Torx T20 Procedure: 5-10 minutes Step 1: 1) Turn Wheel for more space. 2) Remove (1x) One Inner Fender screw...

Hey all, I have been following this forum daily for the last 6 months. Very Helpful. Thank you all for contributing. I figured I would too. Here's a pic of Mission E wheels with all the different colored calipers (except Red which I couldn't find). Cheers, Nai