rb33gl
Well-Known Member
- First Name
- Richard
- Joined
- Jun 24, 2021
- Threads
- 9
- Messages
- 241
- Reaction score
- 218
- Location
- UK
- Vehicles
- Taycan, Audi A3 TFSIe Hybrid, Porsche 964 (gone..)
- Thread starter
- #1
Just had an interesting experience with the 12v battery. On returning home for a 2 week holiday, I found the car wouldn’t unlock. All buttons on the remote created a red signal on the fob – no opening of doors, boot or bonnet.
Changed the fob battery, held the fob at the top right of the rear windscreen, still no joy. Tried the emergency key – no result - I could hear nothing and the door wouldn't open.
So I called Porsche Assist, which in the UK is operated by the AA. They were very good, arriving in 40 minutes (turned out the guy lives 10 minutes away and we were his first job on Monday morning, so he even had time to fill up).
He called up Porsche’s manual on his iPad and found there is a technique with the emergency key the owner’s manual doesn’t tell you about. You have to put the key in and turn it clockwise and hold it in that position for about 5 seconds. The door handle can then be operated manually.
Once inside the car, he connected a 12v supply to the fuse box (which is well documented elsewhere on this forum) to open the bonnet. He then connected a 12v charger to the Lithium battery and after a few minutes the car sprang into to life. The PCM system gave a warning 12v battery low, connect to charger warning, but this disappeared after a few on-off cycles.
It’s clear even a small Lithium battery should last longer than 2 weeks and I wanted to make sure it had plenty of charge, so I call the OPC to find out the best way of doing this. If you don’t have a Lithium battery charger (my CTEK is only for lead batteries) it can only be done by driving it. They said the car’s alternator (??) will do this, but couldn’t say how long it took.
Interestingly, they didn’t seemed concerned about a software update for the battery monitoring system either, saying it might have been caused by “Germany fiddling with some of the Connect settings”.
I drove around and found the state of charge readout in dial 3 read 13.4v initially, and after a few miles was showing 14.5v before falling back to 13.5v. Nothing that would suggest a fault.
Plugging in the charger to the main battery doesn’t do anything either. Once the charge in the 12v has dropped to a low level (what that is, heaven knows) it will cut supply to all the controls to protect itself. Seems bizarre you can be sitting on 93kw and not be able to open the doors...
I don't really trust this battery now but don't really want ot book it in for another 2 days, especially when the OPC say no software change is needed.
Changed the fob battery, held the fob at the top right of the rear windscreen, still no joy. Tried the emergency key – no result - I could hear nothing and the door wouldn't open.
So I called Porsche Assist, which in the UK is operated by the AA. They were very good, arriving in 40 minutes (turned out the guy lives 10 minutes away and we were his first job on Monday morning, so he even had time to fill up).
He called up Porsche’s manual on his iPad and found there is a technique with the emergency key the owner’s manual doesn’t tell you about. You have to put the key in and turn it clockwise and hold it in that position for about 5 seconds. The door handle can then be operated manually.
Once inside the car, he connected a 12v supply to the fuse box (which is well documented elsewhere on this forum) to open the bonnet. He then connected a 12v charger to the Lithium battery and after a few minutes the car sprang into to life. The PCM system gave a warning 12v battery low, connect to charger warning, but this disappeared after a few on-off cycles.
It’s clear even a small Lithium battery should last longer than 2 weeks and I wanted to make sure it had plenty of charge, so I call the OPC to find out the best way of doing this. If you don’t have a Lithium battery charger (my CTEK is only for lead batteries) it can only be done by driving it. They said the car’s alternator (??) will do this, but couldn’t say how long it took.
Interestingly, they didn’t seemed concerned about a software update for the battery monitoring system either, saying it might have been caused by “Germany fiddling with some of the Connect settings”.
I drove around and found the state of charge readout in dial 3 read 13.4v initially, and after a few miles was showing 14.5v before falling back to 13.5v. Nothing that would suggest a fault.
Plugging in the charger to the main battery doesn’t do anything either. Once the charge in the 12v has dropped to a low level (what that is, heaven knows) it will cut supply to all the controls to protect itself. Seems bizarre you can be sitting on 93kw and not be able to open the doors...
I don't really trust this battery now but don't really want ot book it in for another 2 days, especially when the OPC say no software change is needed.
Sponsored
at me having to research how to unlock my car door..... )