Taycan Instrument Cluster: 3 dial set up?

[BigAndy1234]

I was slower on the reply, but this is exactly correct!

Thanks a lot you and everyone else. Finally worked it out. Was pressing before scrolling :-(

Sponsored

 

[W1NGE]

Just got my new 4S (live in California) and absolutely love it. Watching a set up video it seemed that there were multiple options for the 3 dials in the instrument cluster. However, for the left one all I am seeing is 2 tyre pressure views and for the centre (speed) one just power meter. Am I missing something ?

There are 7 views in total if selected from Displays in the PCM.

I think your problem is navigating the buttons on the steering wheel.

Use the <> to select the tube and then press down on ithe tumb wheel to select. Selected tube is marked in orange. Whichever tube is active press the thumb wheel again to see the tube menu then scroll it to select the view and press again to select. When your view is displayed press the thumb wheel again to see what options there are for that display.

 

[UKPerson]

Your answer was quite extensive and I'm sure that OP will get this resolved as a result. That's one of the reasons I love this forum, because so many people jumped in right away to try and assist the OP. If the other posts on this forum are any indication, this thread will now derail and go way off topic (in a good way).

Has anyone mentioned depreciation? ?

 

[Gru]

thanks to this thread, I discovered the existence (after 1.5 yr....) and use of this small button !

 

[BigAndy1234]

There are 7 views in total if selected from Displays in the PCM.

I think your problem is navigating the buttons on the steering wheel.

Use the <> to select the tube and then press down on ithe tumb wheel to select. Selected tube is marked in orange. Whichever tube is active press the thumb wheel again to see the tube menu then scroll it to select the view and press again to select. When your view is displayed press the thumb wheel again to see what options there are for that display.

Yes, thanks. Feel a bit of a fool - was pressing / scrolling in the wrong order :-(

 

[Propofoln]

As a side note to this thread, is there any way to remove the scattered little yellow icons I guess signifying road construction on the map screen in the middle of the screen behind steering wheel? I can zoom in and out but any way to clean it up?

 

[W1NGE]

As a side note to this thread, is there any way to remove the scattered little yellow icons I guess signifying road construction on the map screen in the middle of the screen behind steering wheel? I can zoom in and out but any way to clean it up?

Don't think so. Driven by the PCM NAV settings - POI etc - perhaps check there

 

[Payton3485]

On the right side of the steering wheel, press the back button when you are on the options for the tires on the left ring. That will open up the other options under this ring.

Funny enough, I had the same issue on mine and by luck I pressed the back button and voila, that brought me to the other options available.

Good luck!

 

[Dave Birch]

You can't put maps in the center tube? I find them sort of distractingly dizzying, but I would expect that to be there.

I have a CT4S 2023 and can have map in centre.

 

[W1NGE]

I have a CT4S 2023 and can have map in centre.

It's the only place on the instrument display where the map can be and can then be extended across all 3.

The NAV (when active) will push directions to the right tube in the instrument display.

Same for all Model Years of Taycan (and I guess new Cayenne and Macan EV) - same display.

 

[24Neptune]

It’s possible that all of the options for the tubes are not showing bc you have to check mark them in the PCM to have them show as options in the tubes. Settings, Display, Instrument Cluster..

 

[Jasper4S]

thanks to this thread, I discovered the existence (after 1.5 yr....) and use of this small button !

Omg haha I need to know, what does this button do?

 

[24Neptune]

Driver Assistance mode

 

[D00notD00d]

There’s lots of you tube content that covers the Taycan instrument cluster. I think some changes can only be applied when you’re stationary - that may be why you’re not seeing all options

 

[hifi239]

Omg haha I need to know, what does this button do?

I needed to check also.

Sponsored